Lack of salt indicator (*applicable models only)
-Turns on when the water softener runs out of salt. (or the dishwasher is in the standby or pause modes.)
-Turns off while the dishwasher is operating.
Delay a cycle for up to 24 hours in
- After setting the delay time, press the Start button, and then close the
10 Delay Start
door to start the cycle.
-If you want to change the delay time once the dishwasher has started, press the Reset button and turn off the dishwasher. Then, turn on the dishwasher again and select a new cycle with a new delay setting.
To start a cycle, press the Start button before closing the door.
| *Reset : To cancel a currently running cycle and drain the dishwasher, press |
11 Start | and hold the Start button for three (3) seconds. |
Once the dishwasher is reset, select a cycle and option, and then press Start to restart the dishwasher.
You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) before starting a cycle. If you change the cycle after selecting an option, the original cycle is reset.
To prevent the touchpad from losing response sensitivity, follow these instructions:
-Touch the center of each keypad using one fi nger. Do not push.
-Clean the touch control’s surface regularly with a soft, damp cloth.
-Be careful not to touch more than one touch key pad at a time, except as directed.
When you pause a cycle by opening the door during operation, press the Start button before closing the door to continue the cycle.
O O X
03 using your dishwasher
English - 11
