ŝ143Ş
Setting the Exposure
4. Press the button twice.
- Shooting is ready and is displayed on the LCD panel.
5. Press the shutter release button halfway.
- Focus indicator appears in the viewfinder when focused.
6. Press the shutter release button fully.
- Three consecutive pictures will be taken, the first with no compensation, the second
with negative compensation, and the third with positive compensation.
ƃWhen the focus mode is set to (Single mode), the focus is locked in the first frame position
and used for subsequent consecutive frames.
ƃThe auto bracketing exposure setting will remain effective for twice as long as the exposure
metering timer (default setting is 20 seconds)
when you release your finger from the shutter release button during auto bracketing, and you can
take the next picture at the next compensation value.
In this case, auto focusing works for each frame. After about twice as much time as the exposure
metering timer (default setting is 20 seconds), the camera returns to settings for taking the first
picture.
ƃYou can combine Auto Bracket with the built-in flash or external flash (P-TTL auto only) to change
only the flash output continuously. However, when using an external flash, holding the shutter
release button down to take three continuous frames may cause the second and third frame to be
taken before the flash is fully recharged. Always take one frame at a time after confirming that
charging is complete.
ƃAuto Bracket is not available when the exposure mode is set to (Bulb) mode.
INFORMATION