Samsung HMX-Q10BNIHMX-Q100BNIH MXOQ130BN, HMX-Q10TNIHMX-Q100TNIHMXDQ130TN Gettin 9 started

							67_
	•	@	!	.....			_II	.......		"
Video	resolution			Full	HD				SD
Continuous	recording		time	Approx.	105	mis.		Approx.	120	rain.
Playback		time		Approx.	140	mis.		Approx.	160	rain.

*Charging time: Approximate time in minutes required to fully charge a completely exhausted battery.

*Recording/Playback time: Approximate time available when you have fully charged the battery. 'FullHD'stands for high definition image quality and 'SD' stands for standard image quality.

*Times shown above are measured under Samsung's test conditions. Your times may differ, depending on your usage and conditions.

*The recording and playback times will be shorter when you use your camcorder in low temperatures.

*We recommend using the AC power adaptor when using the Time Lapse REC function.

[_[] * The charging time will vary depending on the charge remaining in the battery.

•The battery is charged over 95% after about 2 hours, and the indicator color changes to green. It takes about 2 hours and 40 minutes for the battery to charge 100%.

The continuous recording time above shows the available recording time when you record without using any other function after recording starts. The battery may discharge 2-3 times faster than this reference if you use the recording start/stop, the zoom, and the playback functions. Prepare additional batteries with the expectation that the actual recording time is about 1/3 to 1/2 of the times listed above.

We recommend that you use the AC power adaptor to power the camcorder from a household AC outlet when recording and playing the camcorder indoors. The connection is the same as that for battery charging. '_page 22

Gettin 9 started

Battery Properties

A lithium-ion battery is smal-sized and has a high capacity. Low ambient temperature (below 50°F (10°0)) may shorten its usage time and affect its function. Before recording in low temperatures, put the battery into your pocket to warm it, then install it in the camcorder.

Make sure to store the battery separately after use.

-A small amount of battery power is consumed when the battery is stored in the camcorder even if the camcorder power is off.

-The battery may be completely discharged, if it has been installed and left in the camcorder for a long period of time. If this occurs, the battery may not fully operate even if you charge it.

-If the battery is not used for a long time, fully charge the battery and then, using your camcorder, drain the charge completely once every 3 months to keep the battery functioning properly. To store the battery, remove it from your camcorder and put it in a cool, dry place.

Charge an extra battery before using the cameorder outdoors in cold temperatures.

-The cold temperature may shorten the available recording time.

-Carry the supplied AC power adaptor to charge the battery while travelling. Check whether the battery terminal is damaged if the battery falls or is dropped.

-If you install a battery with the damaged terminal into the camcorder, you can damage the camcorder.

Remove the battery and the memory card from the eamcorder and disconnect the AC power adaptor after use.

-Store the battery in a stable, cool and dry place.

(Recommended temperature : 59°F - 77°F (15°O - 25°0), recommended

humidity: 40%- 60%)

-Temperatures that are too high or too low shorten the battery lifetime.

-The battery terminals can become rusty or malfunction if the battery is stored in a smoky or dusty location.

Recycle or dispose of your dead batteries properly.

The battery lifetime is limited.

-Battery capacity decreases over time and through repeated use. If decreased usage time between charges becomes significant, it is probably

time to replace the battery with a new one.

-Each battery's life is affected by storage, operating, and environmental conditions.