Connecting to a PC
This PDP set is not compatible with Macintosh PC.
Power Plug
PC (15pin) | Audio Cable |
Cable | BNC |
| Cable |
Connecting a PC to the PDP
1 Connect a PC (15pin) or BNC cable between the Video Output jack on the PC and the RGB1 (15p
•You can attach the Ferrite Cores to each jack of the BNC cable.
•For an explanation of Component video, see your PC owner’s instruction.
2 Connect a Audio cable between the Audio Output jack on the PC and the Audio Input (PC) on the PDP.
To watch the PC screen:
1.Turn on PDP and press the RGB button to select the PC mode.
2.Turn on PC and check for PC system requirements. (Refer to pages 42 and 43 for PC system requirements.)
3.Adjust the PC screen. (Refer to page 44.)
42
Pin Configuration
• 15Pin Signal Cable (based on protruded pin)
Setting up Your Monitor Plug and Play
Our adoption of the new VESA Plug and Play solution eliminates complicated and time consuming setup. It allows you to install your monitor in a Plug and Play compatible system without the usual hassles and confusion. Your PC system can easily identify and configure itself for use with your display. This monitor automatically tells the PC system its Extended Display Identification data (EDID) using Display Data Channel (DDC) protocols so the PC system can automatically configure itself to use the flat panel display.
43
