Connectingthe FM and AM Antennas, Selecting Resolution

1p~40p(410HD)-GB 7/27/04 4:58 PM Page 18

Connectingthe Video Out to TV

You can adjust the resolution switch to set the DVI and component (PR, PB, Y) output resolution to 576p(480p)/720p/1080i.

Connectingthe FM and AM Antennas

If AM reception is poor, connect an outdoor AM antenna(not supplied).

Example: If the TV supports resolution up to 576p(480p)

• A 576p(480p) video signal is output through the DVI and component outputs (PR, PB, Y).

Caution

•	If you connect the DVI and Component outputs (PR, PB, Y) at the same time, Component output resolution changes
	automatically to the designated DVI resolution.
	Note
•	If copy protection is in place, output resolution is automatically converted to 576p(480p) when you play the
	DVD, even if you set the resolution to 720p or 1080i.

DCDi (Directional Correlational Deinterlacing) Function

Converts the interlace signal to progressive to prevent flickering and to remove distortion or noise on the edge of screen.

Press and hold DCDi button on the remote control for over 3 seconds.

FM Antenna (supplied)

1.Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal as a temporary mea- sure.

2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.

AM Loop Antenna (supplied)

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

2.If reception is poor, connect an outdoor single vinyl-covered wire to the AM ter- minal. (Keep the AM loop antenna con- nected).

CONNECTIONS

• Each time the button is pressed, the selection alternates between

DCDi ON and DCDi OFF.

	Cooling Fan	The cooling fan dissipates the heat generated inside the unit so that the unit can be operated
	Cooling Fan	normally. The cooling fan is activated automatically to supply cool air to the unit.

		Please observe the following cautions for your safety.
		• Make sure the unit is well-ventilated. If the unit has poor ventilation, the temperature inside the unit could rise
		and may damage it.
		• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a
		newspaper or cloth, heat may build up inside the unit and fire may result.)