Setting the Speaker Mode
Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.
Setting the Test Tone
Use the Test Tone feature to check the speaker connections and to adjust the speaker levels.
1
In Stop mode, press MENU button.
Press Cursor 
2 button to move to ‘Audio’ and then
press ENTER button.
Press Cursor 
, 
,
In Stop mode,
1 press MENU button.
Press Cursor 
2 button to move to ‘Audio’ and then
press ENTER button.
3 | Press Cursor button | |
to move to ‘TEST | ||
| ||
| TONE’ and then press | |
| ENTER button. |
•The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in that order.
If the ENTER button is pressed again at this time, the test tone will stop.
3
In the Speaker Setup, press the ENTER button again.
, 
buttons to move 4 to the desired
speaker and then press ENTER button.
•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
Press RETURN button to return to the previous level. |
|
| SETUP |
|
|
| |
|
|
|
|
|
|
|
|
Press MENU button to exit the setup screen.
SMALL : Select this when using the speakers.
NONE : Select this when no speakers are installed.
Note |
•Depending on PRO LOGIC and STEREO, the speaker mode may vary.
53
Alternate method: press the TEST TONE button on the remote.
Press TEST TONE button.
•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.
•Use this function to check that each speaker is correctly connected and that there is no problem.
To end the test tone,
press TEST TONE button again.
L: Front Speaker (L) | C: Center Speaker | SW: Subwoofer |
R: Front Speaker (R) | LS: Rear Speaker (L) | RS: Rear Speaker (R) |
Start
54
