Setting DRC (Dynamic Range Compression)

Test Tone

GB

You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.

√

MAIN UNIT

1 Press SETUP button.

•“SETUP MODE” appears on the display and enters into Setup Mode.

2 Press INPUT button 3 times.

•“DRC SETUP” appears on the display.

3 Press SURROUND button to set DRC.

•Each time you press this button, DRC : STD ➝ DRC : MAX ➝ DRC : MIN will be selected in turn.

To Exit Setup Mode

•Wait for about 5 seconds or turn the VOLUME CONTROL of the main unit. “SETUP MODE OFF” appears on the display and exits Setup Mode.

Use test tone to check the speaker connection status or level.

To Automatically Output Test Tone

√

REMOTE CONTROL

1 Press TEST TONE button.

•Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝ S.R

➝ S.L ➝ S.W.

•During test tone output, press …† button to adjust the speaker output level

from -10 to +10 dB by 1 step.

OPERATION

To Stop Test Tone

•Press TEST TONE button again.

Setting DRC

• STD : Sets DRC effect to standard.

• You can only set this function via the main unit.

•MAX : Sets DRC effect to maximum.

•MIN : Sets DRC effect to minimum.

21

22