Before Calling for Service

SymptomCheckRemedy

GB

Symptom

Check

Remedy

Can't turn it on.It does not work when the button is pressed.Sound is not produced.

Picture does not appear when the function is selected.

Remote controller does not work.The sound from each device is changed during stereo playback.Can't receive broadcasting.

Is the power code plugged into the outlet?

Is there static electricity in the air?

Are the speaker and external component connected properly?

Does the Mute function work?

Is the volume set to minimum?

Is the speaker setup selected to NONE?

Isn’t the external component connected properly?

Are the batteries exhausted?

Is the distance between remote control and main unit proper?

Is the left/right speaker or left/right input/output code connected properly?

Is AM or FM antenna connected properly?

Connect the power plug to the outlet.

Disconnect the power plug and connect it again.

Properly connect it.

Press Mute button to cancel the function.

Adjust the volume.

Refer to pages 17~18 to select LARGE, SMALL or YES.

Properly connect it.

Replace with new batteries.

Operate at close distance.

Check the left/right channel and properly connect it.

Properly connect the antenna.

If the input strength of antenna connector is weak, install the FM antenna in a place with good reception.

Can't select Dolby Pro Logicll Mode.There is no sound when playing DTS encoded DVD and CD.

• Is the input signal selected properly?

• Select 2 channel Dolby Digital, PCM, and

 

Analog input signal.

• Is analog input selected?

• Check whether digital external component

 

is properly connected and refer to page

 

13 to select the digital input.

There is no sound fromsurround speaker.

There is no sound from

center speaker

Is the surround speaker connected properly?

Is S.SPK (Surround) set to NONE in Speaker Setup?

Is Surround Mode selected to Stereo?

Is the center speaker connected properly?

Is C.SPK (Center) selected to NONE in Speaker Setup?

Is the Surround Mode selected to Stereo?

Refer to pages 9~10 to connect it properly.

Refer to pages 17~18 to select LARGE or

SMALL.

Refer to pages 20~34 to select other Surround Mode.

Refer to pages 9~10 to connect it properly.

Refer to pages 17~18 to select LARGE or

SMALL.

Refer to pages 20~34 to select other Surround Modes.

Product Protection FunctionHeat Protection

Protection function works if the main unit is overheated or power transformer is overheated.

appears in the display when the “ function” works.

-If speaker terminal is shorted

-If speaker cord is shorted

If there is no problem when you turn it on again after turning it off, PROTECTION mark will disappear on the display and the unit will work properly.

MISCELLANENOUS

If PROTECTION appears on the display, check whether speaker terminal is shorted and then turn on the device.

45

46