Samsung HT-D455K/SQ Adjusting the height of the Half Tallboy Speaker, Connecting The Speakers

Connections

Adjusting the height of the Half Tallboy Speaker

*HT-D453HK only - Front Speakers

1.If you want to adjust the height of the speaker, loosen 3 screws on the rear of the speaker base fi rst.

2.Pull up the speaker in the arrow direction. (See fi gure 2)

!CAUTION : Be careful as an excessive force may result in a physical damage.

3.Fit the speaker in a height adjusting hole of your choice. For the height information, check the following examples. (570mm for the default height)

Ex) Hole 1: 650mm in the speaker height Hole 2: 635mm in the speaker height

4.Close the cover as shown and tighten back the 3 screws.

5.This is after the height of the speaker is adjusted. You can repeat these steps above at any time if you want to readjust the height.

1

3

5

2

4

Connecting The Speakers

1.	Press down the terminal tab on the back of the speaker.
2.	Insert the black wire into the black terminal (–) and the red wire into the red
	terminal (+), and then release the tab.
3.	Connect the connecting plugs to the back of the product by matching the	Black
	Colors of the speaker plugs to the speaker jacks.

In case of HT-D450K

Red

Front Speaker (R)

Surround Speaker (R)

Center Speaker

Front Speaker (L)

Surround Speaker (L)

Subwoofer

* Refer to page 16 for the speakers of HT-D453K/D453HK/D455K.

1 English