Installing the Speakers on the Tallboy Stand

Connections 02

*HT-D5530 only - Front Speakers*HT-D5550 only - Front/Surround Speakers1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4x20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION

When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5x15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Connecting The Speakers

1

3

5

Stand

Base

Stand

Speaker

Stand

or

2

4

1. Press down the terminal tab on the back of the speaker.

2. Insert the black wire into the black terminal (–) and the red wire into the red terminal (+), and then release the tab.

3. Connect the connecting plugs to the back of the product by matching the

Black

Red

colours of the speaker plugs to the speaker jacks.

 

 

In case of HT-D5500
Front Speaker (L)

 

 

 

Surround Speaker (L)

 

SPEAKERS OUT

Front Speaker (R)

 

CENTER

FRONT

SURROUND

Centre Speaker

 

 

 

 

 

SUBWOOFER

FRONT

SURROUND

Surround Speaker (R)

 

SPEAKER IMPEDANCE : 3

 

 

Subwoofer

ONENTT OUT

CENTER FRONT SURROUND

 

 

SPEAKERS OUT

 

 

 

 

SUBWOOFER FRONT SURROUND

 

 

VIDEO OUT

SPEAKER IMPEDANCE : 3

 

 

* Refer to page 18 for the speakers of HT-D5530/HT-D5550.

English 19

HT-D5500_ELS_1226.indd 19

2011-12-26 ￿￿ 1:23:48