How to Link the Wireless Transmitterwith the Main Unit1.Turn off your Home Cinema.2.Press the 4, 7, 6, 3 buttons on the remote control in order.•The Power LED blinks once.3.Connect the iPod/iPhone to the Wireless transmitter.

LINK

STANDBY

CHARGE

4.Turn on the iPod/iPhone. Press the "ID SET" button on the back of the Wireless transmitter for 5 seconds. The link light on the wireless transmitter blinks rapidly.

5.Turn on your product.•To listen to music from iPod/iPhone over theproduct, press the button to select "W. IPOD" mode.

•After you select "W. IPOD" mode, turn the volume of the product down to avoid hearing damage.

•You can control the speaker volume of iPod/ iPhone with a volume wheel or a volume bar.

•When iPod/iPhone is stopped or in a power saving mode, the Wireless transmitter enters Sleep Mode.

When iPod/iPhone is set to Deep SleepMode, the Wireless transmitter turns off.
Operation status of the wireless transmitter's LED

LINK

 

 

 

STANDBY

 

 

LINK

 

 

STANDBY

 

 

CHARGE

 

 

Function

Display

LINK

STANDBY

 

 

(Blue LED)

(Red LED)

 

Pairing

 

LED ON

successfully

STANDBY

 

completed

 

LED BLINK

Processing iPod/

LOW BATTERY

(Long blink)

iPhone

 

LED BLINK

Processing

Pairing failed

(Short blink)

pairing

 

!CAUTION

If you use the main unit near a wireless device such as a laptop computer, an AP, or Wifi, an unstable operation error can occur.

Do not pair the SWA-5000 and iPod/iPhone at the same time. If you pair them at the same time, the iPod/iPhone and SWA-5000 may not connect to the product.

The transmission distance from the product to the wireless transmitter is about 5 meters, but may vary depending on your operation environment.

The audio signal may be weakened or even lost where there is an obstacle such as a wall or partition between the product and wireless transmitter. You can also weaken or lose signal

if you move the wireless transmitter around.

Functions Basic 04

English 61

HT-D5500_ELS_1226.indd 61

2011-12-26 ￿￿ 1:25:01