Samsung HTF5500WZA, HT-F5500W user manual Wireless Network, Wpspbc

❑Wired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the E button.

The product searches for a network, and then displays the connection failed message.

NOTES

If it is possible to connect the home theater to your network wirelessly, select Change Network at this point, change the Network Type to Wireless, and then go to the instructions for wireless networks on page 25.

Network Settings

Wired network connection failed.	XX:XX:XX:XX:XX:XX
MAC Address
IP Address	0.	0.	0.	0
Subnet Mask	0.	0.	0.	0
Gateway	0.	0.	0.	0
DNS Server	0.	0.	0.	0

Wireless Network

You can setup a wireless network connection in three ways:

-Wireless Automatic

-Wireless Manual

-WPS(PBC)

Before you configure the wireless network connection, disconnect any wireless network device currently connected to the product or, if applicable, the product's current wired connection.

❑Wireless - Automatic

After following Steps 1 to 3 in "Configuring Your Network Connection" on page 24:

1.In the Network Settings screen, change Network type to Wireless. Then, select Connect and press the E button.

The product searches for and then displays a list of the available networks.

Network Settings

Select your network type.

04 Settings

Unable to connect to the network. Try the following: check if your IP address is set correctly in IP Settings. Contact your Internet Service Provider for more information.

Change Network IP Settings Retry Close

2. Use the ◄► buttons to select IP Settings, and

Network type Wireless

Wireless Network

si-ap iptime iptime5G

KIMING_VTOWER

TIAS

You can connect your TV to the internet. Please select which wireless network to use.

Please select your preference.

	then press the E button. The IP Settings screen
3.	appears.
	Select the IP Setting field, and then set it to Enter
4.	manually.
	Select a value to enter (IP Address, for example),
	and then press E. Use the number keypad on
	your remote control to enter the numbers for the
	value. You can also enter numbers using the ▲▼
	buttons. Use the ◄► buttons on the remote control
	to move from entry field to entry field within a value.
5.	When done with one value, press the E button.
	Press the ▲ or ▼ button to move to another value,
	and then enter the numbers for that value following
6.	the instructions in Step 4.
	Repeat Steps 4 and 5 until you have filled in all
	values.

NOTES

You can get the Network values from your Internet provider.

7.When finished entering all the values, select OK, and then press the E button. The home theater verifies the network connection and then connects to the network.

WPS(PBC) Refresh

2.Select the desired network, and then press the E button.

3.On the Security screen, enter your network's security code or pass phrase.

Enter numbers directly using the number buttons on your remote control. Enter letters by selecting a letter with ▲▼◄► buttons, and then pressing E button.

4.When finished, select Done, and then press the E button. The product verifies the network connection and then connects to the network.

NOTES

You should be able to find the security code or pass phrase on one of the set up screens you used to set up your router or modem.

English 25