Samsung HT-H4550R/TK manual Using the TV Sound Button on the Remote Control, „„ Use TV Sound

cinema. (See page 15.)

Set Anynet+ (HDMI-CEC) On in the home cinema and TV.

Press the TV SOUND button on the remote control. TV SOUND ON flashes on the display on the front panel, and then changes to D. IN.

Media Play

About characters shown in the display

When the display shows PS,or RT signals,the following characters are used.

•The display window cannot differentiate upper case and lower case letters and always uses upper case letters.

•The display window cannot show accented letters, <A,> for instance, may stands for accented <A’s> like <À, Â, Ä, Á, Å and Ã.>

PTY (Program Type) indication and

PTY-SEARCH function

One of the advantages of the RDS service is that you can locate a particular kind of program from the preset channels by specifying the PTY codes.

To search for a program using the PTY codes

„„ Before you start!

•The PTY Search is only applicable to preset stations.

•To stop searching any time during the process, press 5 button while searching.

•There is a time limit in doing the following steps.

If the setting is cancelled before you finish, start from step 1 again.

•When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.

RDS DISPLAY		TA
1	2	3
PTY -	PTY SEARCH	PTY +
4	5	6

1.Press the PTY SEARCH button while listening to an

FM station.

2.Press the PTY- or PTY+ button until the PTY code you want appears on the display.

•The display gives you the PTY codes described to the right.

3.Press the PTY SEARCH button again, while the PTY code selected in the previous step is still on the display.

•The centre unit searches 15 preset FM stations, stops when it finds the one you have selected, and tunes in that station.

Using the TV SOUND Button on the Remote Control

If you have a TV that supports Anynet+ (HDMI-CEC), the TV SOUND button lets you direct the TV's audio to the home cinema speakers or the TV speakers. To use, follow these steps:

1.Connect an HDMI cable to the TV and home

2.

3.

• When TV SOUND is on, TV audio outputs through the home cinema speakers.

4. Press the TV SOUND button again to turn TV SOUND off.

• When TV SOUND is off, TV audio outputs through the speakers of the connected Anynet+ TV.

„„ Use TV SOUND:

1)When you want to listen to the TV's audio through the home cinema speakers.

2)When you want to listen to the audio from a USB device plugged into the TV through the home cinema speakers.

„„ TV SOUND ON/OFF support specification

Connected TV	Anynet+	TV	TV
	(HDMI-CEC)	Sound	Sound
	Setting	ON	OFF
Anynet+	ON	O	O
(HDMI-CEC)
	OFF	O	X
supported TV
Anynet+
(HDMI-CEC) not	No operation	O	X
supported TV

28 English