Connections

Surround Speakers

Subwoofer

Place these speakers to the side of your listening position. If there isn't enough room, place these speakers so they face each other. Position them about 60 to 90cm above your ear, facing slightly downward.

*Unlike the front and centre speakers, the surround speakers are used mainly for sound effects. Sound will not come from them all the time.

The position of the subwoofer is not so critical. Place it anywhere you like.
*Surround speakers must be connected to the wireless receiver module.

*The appearance of your speakers may differ from the illustrations in this manual.

*Each speaker has a coloured label on its back or underside. Each cable has a single coloured band near its end. Match the band on each cable to the speaker label by colour, and then connect the cable to the speaker. See page 11 for exact instructions.

Installing the Speakers on the Tallboy Stands
* HT-J7750W only

1.Find the speaker cable that is attached to the Stand. Turn the Stand and Stand Base upside-down, unravel the speaker cable, and then draw it through the hole in the Stand Base.

Handle the Stand carefully. It is heavy.2.Connect the Stand Base to the bottom of the Stand.

3.Insert three 5x20 screws into the marked holes in the Stand Base, and then tighten them with a screwdriver as shown in the illustration.

4.Place the speaker cable into the slot on the bottom of the stand base.

5.Connect the assembled stand and a speaker together by matching the labels on the stand and speaker with each other as shown in the picture.

6.Insert a screw (5x20) into the hole on the rear of the speaker and tighten by turning it clockwise with a screwdriver.

7.Repeat steps 1 through 6 with the other speaker and stand.

1

2 Stand Base
Stand

34

5 6

Speaker

Stand

10 - English