FUNCTIONS

SOFTWARE UPDATE

Samsung may offer updates for the Soundbar's system firmware in the future.

If an update is offered, you can update the firmware by connecting a USB device with the firmware update stored on it to the USB port on your Soundbar.

Note that if there are multiple update files, you must load them onto the USB device singly and use them to update the firmware one file at a time.

Please visit samsung.com or contact the Samsung call centre to receive more information about downloading updates files.

● I nsert a USB device containing the firmware update into the USB port on the main unit.

● Updating firmware may not work properly if

audio files supported by the Soundbar are

stored in the USB storage device.

● Do not disconnect the power or remove the

USB device while updates are being applied.

●Once the software update is completed, turn off the product and then press and hold the ( &) button on the remote control for more than 5 seconds. “INIT” appears on the display and the unit is powered off. The updgrade is complete.

●Do not format the USB device in the NTFS format. The Soundbar does not support the NTFS file system.

●Depending on the manufacturer, some USB devices may not be supported.

AUTO POWER LINK

If you have connected the main unit to a TV with a digital optical cable, set the Auto Power function ON to have the Soundbar turn on automatically when you turn the TV on.

AUTO POWER LINK

Display

The main unit will turn off automatically after

ON

ANYNET+ OFF /

completing the firmware update.

●

POWER LINK ON

After the update, all settings are reset to their

OFF

ANYNET+ ON /

factory default settings. We recommend you

write down your settings so that you can

easily reset them after the update. Note that

updating firmware resets the subwoofer

connection too. If connection to the

subwoofer is not re-established automatically

after the update, refer to page 15.

If the firmware fails to update, we recommend

formatting the USB device in FAT16 and

trying again.

POWER LINK OFF

1.Connect the Soundbar and an External Device with an Optical cable.

2.Press the (Function) button on the main unit’s top panel or the SOURCE button on the remote

control to select the D.IN mode.

3.Press the Anynet+ button on the remote control to toggle the Auto Power Link function on and off.

● Depending on the connected device, Auto Power Link may not function.

24