Cooling Your Room
You must select the COOL mode if you wish to adjust the : ◆ Cooling temperature
◆ Fan speed when cooling
1 If necessary, press 
(ON/OFF) button.
Result: ◆ The On/Off indicator on the wired remote controller comes on.
◆ The air conditioner runs in the mode selected when ◆ the unit was last used.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
2 To select the COOL mode, press the Mode button until 
is displayed at the top of the wired remote controller.
Result: ◆ The air conditioner runs in COOL mode.
Note You can change modes at any time.
3 To adjust the temperature, press the Temperature buttons one or more times until the required temperature is displayed. Possible temperatures are between 18OC and 30OC inclusive.
Result: ◆ Each time you press Temperature buttons: - The temperature is adjusted by 1OC.
◆ The air conditioner starts cooling, provided that the room
◆ temperature is higher than the selected temperature ; the fan
◆will, however, operate.
4Select the fan speed by pressing the Fan button one or more times until the intended value is displayed :
Automatic(rotated : 
➔ 
➔ 
)
Low
Medium
High |
5 To control the direction of the air flow, refer to page 17.
