2Using "HUB Monitor"
This is achieved by an internal chip that transmits data received via the LAN cable to the PC as a converted USB signal.
Connecting to a LAN via Wireless USB
LAN
Connecting to a LAN via USB cable
LAN | USB CABLE |
This product cannot connect to multiple source PCs at the same time and vice versa.
2.5Configuring the HUB Monitor IP
1After installing the integrated driver for HUB Monitors, go to Control Panel → Network and Internet
→Network and Sharing Center → Change adapter settings.
2You can see that the following two devices are displayed.
a.The user PC’s network device
b.The HUB Monitor’s network device (USB to Ethernet adapter)
The two devices above refer to your PC’s LAN network device and your HUB Monitor’s network device.
To use the Internet using the HUB Monitor’s LAN network, configure the network settings as follows
according to the type of IP you will be using.
2.5.1Dynamic IP
The dynamic IP address mode automatically configures the network settings on the PC using data sent by a server, which allots an IP address. This is possible, owing to the “DHCP (Dynamic Host Configuration Protocol)” service. The service consists of three steps: an IP address allotment request is sent to the DHCP server when the PC boots up, the DHCP server that received the request transmits
2 Using "HUB Monitor" 36
