Before connecting cables

3

Insert and keep the removed Silicone-Barin the marked area to ensure it is not lost.

2

Silicone-Bar

Unfasten the screws, then remove the cover.

Remove the appropriate silicon bar for the thickness of the cable to connect.

Different hole sizes and corresponding cable thickness for each:

7 Ø hole x 1: Insert the 7 Ø cable

5.5Ø hole x 3 : Insert the 5.5 Ø cable 3 Ø hole x 2 : Insert the 3 Ø cable

――If the cable thickness is smaller than the opening, apply silicone for waterproofing after inserting the cable.

4

5

6

Insert the appropriate cable into the hole from which the Silicone-Bar was removed.

The cable should be connected as shown.

Close the cover, then fasten the screws.

――After all the cables are connected, make sure to close the cover and fasten the screws to ensure it is water tight.

25