Inserting Remote Control Batteries
GB
Insert or replace remote control batteries when you:
Purchase the
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.
1 | Place your thumb on the position marked | on the battery |
| compartment cover (rear of the remote control) and push the cover in | |
| the direction of the arrow. |
|
2 | Insert two AA, LR6 or equivalent batteries, taking care to respect the | |
| polarities: |
|
| + on the battery against + in the battery compartment | |
| – on the battery against – in the battery compartment | |
3 | Replace the cover by sliding it back until it clicks into position. | |
|
|
|
If you will not be using the remote control for a long time, remove the batteries to prevent corrosion.
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause performance degradation of the speaker.
Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident caused by falling of the speaker.
Do not take the speaker apart from TV or computer monitor. The speaker near the TV or computer monitor may influence the quality of the screen display.
Connecting the Loudspeakers
The loudspeaker connector terminals are located on the rear of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the – terminals
1 | To connect a wire to a terminal, push the tab as far as it will go: | ||||||||
| To the right on the system | ||||||||
2 | Insert the wire, up to the plastic sheathing, in the hole. | ||||||||
| Push the tab back: | ||||||||
| To the left on the system, until it clicks into place | ||||||||
| To the top on the loudspeaker | ||||||||
| Result: The wire is pinched and held firmly in place. | ||||||||
3 | Repeat the operation for each wire. | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
8
