Viewing the Various Functions on Your System and Dim out for Window Display
You can view the various functions available on your system
and you can also dim out for the window displayer.
1 Press the Demo/Dimmer button.
Result: The various functions available are listed in turn on the display.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate sec- tions.
2 Press Demo/Dimmer again.
Result: The window displayer become dim out .
The window displayer can be used more longer at the dimmer state.
3 Power turn on state ONLY Press Demo/Dimmer again.
Result: The window displayer become normal display .
Setting the Clock
GB
Your system is equipped with a clock which allows you to turn your system on and off automatically. You should set the clock:
When you first purchase the
After a power failure
After unplugging the unit
For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.
1 | Switch the system on by pressing Standby/On. | |
2 | Press Timer/Clock twice. |
|
| Result: CLOCK is displayed. |
|
3 | Press Enter. |
|
| Result: The hour flashes. |
|
4 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the hours | Right |
| Decrease the hours | Left |
5 | When the correct hour is displayed, press Enter. | |
| Result: The minutes flash. |
|
6 |
|
|
To... | Turn the Multi Jog knob to the... | |
| Increase the minutes | Right |
| Decrease the minutes | Left |
7 | When the correct time is displayed, press Enter. | |
| Result: The clock starts and is displayed, even when the system is in | |
standby mode.
You can display the time, even when you are using another function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control to instead Enter button in step 3, 5, 7.
You can also use 
/ 
buttons to instead Multi Jog knob in step 4, 6.
3,5,7 |
2 |
1 |
4,6 |
9
