Samsung MM-DT8R/ELS manual Press REV.MODE until the appropriate symbol is displayed, Power

Selecting the cassette Playback Mode/Repeat A↔ B Function

Timer Function

• The timer enables you to switch the system on or off at specific times.

• If you no longer want the system to be switched on or off automatically, you must cancel the timer.

• Before setting the timer, check that the current time is correct.

• For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

Selecting the Cassette Playback Mode

Your micro component system has three cassette playback modes which enable you to listen to both sides of a cassette automatically.

Press REV.MODE until the appropriate symbol is displayed.

Example: You wish to wake up to music every morning.

Switch the system	Press
	TIMER/CLOCK
on by pressing	until TIMER is
1 POWER.	2 displayed.

Press the ENTER

3 button.

•ON TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch-on time already set; you can set the timer switch-on time.

•When the display indicates...The micro component system plays back

One side of the selected cassette and then stops.

One side of the cassette.

The other side of the cassette and then stops.

Both sides of the cassette indefinitely until you press stop.

REPEAT A↔ B Function

4 Set the timer switch-on time.

a. Set the hour by pressing or button.

b. Press ENTER.

•The minutes flash.

c.Set the minutes by pressing or button.

d.Press ENTER.

•OFF TIME is displayed (instead of the equalizer symbols) for a few seconds, followed by any switch- off time already set; you can now set the timer switch-off time.

5 Set the timer switch-off time.

a. Set the hour by pressing or button.

b. Press ENTER.

•The minutes flash.

c.Set the minutes by pressing or button.

d.Press ENTER.

•VOL 20 is displayed, where 20 corresponds to the volume already set.

Press or button

6 to adjust the volume level and press

ENTER.

•The source to be selected is displayed.

Press REP. A↔ B button.

•Use this to listen to a specific section again during playback.

•Set the start and end points of the section you want to repeat 3 times.

•This is a useful when learning a foreign language.

•The TAPE REPEAT function can be used only on sections that are longer than 7 seconds.

Note	• You cannot set the end point (B) within 7 seconds after
	setting the start point (A).

51

Press or button	8	Press ENTER to
to select the source to
		confirm the timer.
be played when the
7 system switches on.

•TAPE (cassette) : Insert a cassette tape.

•TUNER (radio) : a Press ENTER. b Select a preset

station by pressing Tuning or .

•CD (compact disc) : Load a compact disc.

•USB : Connec the usb.

Note

• If the timer switch on and off times are identical, the word ERROR is displayed.

Press POWER to

9 set the system to standby mode.

• is displayed to the top-right of the time, indicating that the timer has been set.

•The system will switch on and off automatically at the required times.

52

MISCELLANEOUS