Samsung MM-E330/XE manual If no signal is sent, FM frequency, Station frequency non-RDS, Service

PS	While searching, <PS> appears
	and then the station names will
(Program
	be displayed. <NO PS> appears
Service)
	if no signal is sent.
	While searching, <RT> appears and
RT(RadioText)	then text messages the station sends
	will be displayed. <NO RT> appears
	if no signal is sent.
	Decodes the real time clock from the
	FM frequency.
CT (Clock Time)	Some stations may not transmit PTY,
	RT or CT information therefore this
	may not be displayed in all cases.
Frequency	Station frequency (non-RDS
	service)

About characters shown in the display

When the display shows PS,or RT signals,the following characters are used.

●● The display window cannot differentiate upper case and lower case letters and always uses upper case letters.

●● The display window cannot show accented letters, <A,> for instance, may stands for accented <A’s> like

<À, Â, Ä, Á, Å and Ã.>

●● PTY(Program Type) indication and

PTY-SEARCH function(Optional)

One of the advantages of the RDS service is that you can locate a particular kind of program from the preset channels by specifying the PTY codes.

To search for a program using the PTY codes

Before you start!

•The PTY Search is only applicable to preset stations.

•To stop searching any time during the process, press the STOP button while searching.

•There is a time limit in doing the following steps.

If the setting is cancelled before you finish, start from step 1 again.

•When pressing the buttons on the primary remote control, make sure that you have selected the FM station using the primary remote control.

1.Press the RDS PTY button while listening to an FM station.

2.Press the TUNING/ALBUM ,or . buttons until the PTY code you want appears on the display.

•The display gives you the PTY codes described to the right.

3.Press the RDS PTY button again, while the PTY code selected in the previous step is still on the display.

•The centre unit searches 30 preset FM stations, stops when it finds the one you have selected, and tunes in that station.

Setting the Clock

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1.Switch the system on by pressing the POWER button.

2.Press TIMER/CLOCK button and then press the ENTER button,"CLOCK” is displayed.

3.Press ENTER,the hour flashes.

●●Increase the hours:,.

●●Decrease the hours:..

4.When the correct hour is displayed, press ENTER, the minutes flashes.

●●Increase the minutes:,,

●●Decrease the minutes:..

5.When the correct minute is displayed, press ENTER,” TIME" appears in the display.

●● The current time is set now.

●●You can display the time, even when you are using another function, by pressing the TIMER/CLOCK button once.

●●You can also use [ or ] on the top panel instead of TUNING/ALBUM ,or . buttons in step 3,4.

English 11