Where to Install Your Micro-Component System

 

Connecting the Loudspeakers

 

 

 

To take full advantage of your new MICRO component system, follow GB these installation instructions before connecting the unit.

Install the system on a flat, stable surface.Never place this unit on carpeting.Never locate this unit in an outdoor area.

Maintain an open space of approximately 4 inches (10 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

The loudspeaker connector terminals are located on the rear of the system (red and black tabs).

There are four terminals on the system:

Two for the left speaker (marked L)

Two for the right speaker (marked R)

To achieve the correct sound quality, connect the:

Red wire to the + terminals

Black wire to the - terminals

1To connect a wire to a terminal, push the tab as far as it will go:

To the right on the system and hold it in position

2Insert the wire, up to the plastic sheathing, in the hole.

3Push the tab back:

To the left on the system, release the tab.

Result: The wire is pinched and held firmly in place.

4Repeat the operation for each wire.

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:Purchase the Micro component systemFind that the remote control is no longer operating correctly

When replacing the batteries, use a new set of batteries and never mix alkaline and manganese batteries.

1Place your thumb on the position marked on the battery compartment cover (rear of the remote control) and push the cover in the direction of the arrow.

2Insert two AAA, LR03 or equivalent batteries, taking care to respect the polarities:

+ on the battery against + on the remote control

– on the battery against – on the remote control

3Replace the cover by sliding it back until it clicks into position.

Connecting Your System to the Power Supply

The mains lead must be plugged into an appropriate socket.

Before plugging your system into a mains socket, you must check the voltage setting (OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of the unit, you may seriously damage your system.

1Check the position of the voltage selector on the rear of the system (OPTIONAL).

2Plug the mains lead (marked AC CORD on the rear of the system) into an appropriate socket.

3Press the On/Standby button to switch your Micro compact system on.

Option

4