A-4 SAMSUNG Clothes Washer Owner’s Instructions
IMPORTANT TO INSTALLER
Please read the following instructions carefully before installing your Washer.
These instructions should be retained for future reference
STEP 1

Removing the Shipping Bolts

Before using your Washer, you must remove the four shipping
bolts from the back of the unit.
1. Loosen all bolts with the supplied spanner.
2. Slide the bolt and spacer up and remove the bolt with
spacer through the hole in the rear wall of your Washer.
Repeat for each bolt.
3. Fill the holes with the supplied plastic covers.
4. Keep the shipping bolts and spacers for future use.
STEP 2

Selecting a Location

Before you install your Washer, make sure the location:
• Has a hard, level surface
• Is away from direct sunlight
• Has adequate ventilation
• Will not be freezing (below 32°F or 0°C)
• Is away from heat sources such as oil or gas
• Has enough space so that your Washer need not stand on its power cord
• Doesn’t have any carpeting that will obstruct ventilation openings.
STEP 3

Installing your Washer

1. Place the drain hose in the drain facility. Be sure an
airtight connection is NOT made between the drain
hose and the standpipe.
Standpipe must be at least 18 in or 46 cm high.
NOTE: Caution must always be exercised to
avoid collapsing or damaging the drain
hose. For best results, the drain hose
should not be restricted in any way – by
elbows, couplings, or excessive lengths. For
situations where the drain hose cannot be
conveniently elevated to at least 18 in or 46
cm, the drain hose must be supported.
2. Insert new rubber washer (supplied) into each end
of the inlet hoses. Firmly seat the washers in the
couplings.
3.
Check the inlet hose to ensure a washer is inside each fill hose. Thread the inlet hoses to the HOT and
COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and
install each fill hose to the water valve. Make sure the hose with the HOT printed line is attached to the
HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers.
NOTE: For correct water use, connect both HOT and COLD water valves. If one is not connected,
“nF” (no fill) error can occur.
Installing Your Washer
96” Max
18” Min 96” Max
18” Min
Hose
retainer
Tie strap
Laundry tub Stand pipe
WF326LAW-02346B-06-EN-no line.indd 4 2007-04-18 ø¿»ƒ 4:24:28