Samsung Owner's Manual - page 23

SAMSUNG Clothes Washer Owner’s Instructions E-4
Troubleshooting
Code Symbol Meaning Solution
Problem with control. Call for service. See below.
Electric service was lost when
Washer was running.
Restart the cycle by pressing the Cycle Selector
dial.
A fault is detected in the water
level sensor.
Call for service
Jammed Key. Call for service
Motor speed sensor problem. Restart the cycle.
If the code reappears, call for service, see below
Temperature sensor problem. Restart the cycle.
If the code reappears, call for service, see below
High current detected. Restart the cycle.
If the code reappears, call for service, see below
High/Low voltage detected. Restart the cycle.
If the code reappears, call for service, see below
Vibration sensor problem. Restart the cycle.
If the code reappears, call for service, see below
SilverCare™ control problem Restart the cycle.
If the code reappears, call for service, see
below.
Too much SUdS is detected
during the washing session. And,
the unit is put on hold until the
suds get reduced. Then, it will go
back to the operation. When it
finishes washing, End and SUdS
codes will blink in turn.
To prevent it, cut down on detergents.
For any codes not listed above, call 1–800–726–7864 (1–800–SAMSUNG)
WF326LAW-02346B-06-EN-no line.indd 4 2007-04-18 ø¿»ƒ 4:24:53