![Reassembling the freezer door (DRAWER TYPE - RF217,RF197)](/images/new-backgrounds/68623/6862315x1.webp)
Setting up your French Door Refrigerator
Reassembling the freezer door (DRAWER TYPE - RF217,RF197)
Slot
1. Pull out the rails to the full length | 2. Hang the freezer door front onto | 3. With the 10mm wrench, reattach | |
| on each sidle of the cabinet | open slot on the sides. | 4 bolts to connect the rail with |
| evenly. |
| the door. |
|
|
|
|
|
|
|
|
4.With the drawer pulled out fully, insert the drawer box into the rail system.
Reassembling the freezer door (SWING TYPE - RF195)
|
|
|
|
|
|
1. Place the hole in the bottom of | 2. | Replace the middle hinge connected to the freezer. | |||
| the freezer door over the right | 3. | Insert and tighten the screw into the left and right middle hinges with a | ||
| side low hinge. |
| philips screwdriver(+). Insert and tighten the 2 hex head bolts into the | ||
|
|
| left and right middle hinges with an allen wrench(3/16”). | ||
|
| 4. | Replace the cap on the middle hinge. |
ADJUSTING THE DOORS |
| |
Now that the doors are back on the Refrigerator, you want to make sure the Refrigerator is level so that you can |
| |
make final adjustments. If the Refrigerator is not level, it will not be possible to get the doors perfectly even. | 01SETTING | |
| When the Left door is lower than the Right door. | |
| UP | |
| Insert a | |
|
| |
| to level the left door. |
|
|
|
|
Control Lever
When the Left door is higher than the Right door.
Insert a
Control Lever
Both control levers must be surely touching the floor to avoid the possible personal injury or property CAUTION damage because of tipping.
14_ setting up | setting up _15 |