Setting up your French Door Refrigerator
Reassembling the fridge door
3. After opening the Freezer door, | 4. Remove 4 hex head bolts | 5. Lift up the freezer door from the |
lift the drawer box. | from both sides with a socket | rails. |
| wrench(10mm) | Be careful not to drop and |
|
| scratch the freezer door. |
Disassembling the freezer door (SWING TYPE - RF195)
Middle Hinge
1.Insert and tighten the screw into the left and right middle hinges with a philips screwdriver(+).
SETTING01
UP
2. Insert and tighten the 2 hex head 3. Replace the middle hinge cap. bolts into the left and right middle
hinges with an allen wrench(3/16”).
1. Separate the Cap on the Middle | 2. Remove the screw attached to the left and right middle hinges with a |
Hinge. | philips screwdriver(+). |
| Remove the 2 hex head bolts attached to the left and right middle |
| hinges with an allen wrench(3/16”). |
3. Remove the Middle Hinge | 4. Lift up the freezer door from the |
connected to the Freezer. | hinge. |
| Be careful not to drop and |
| scratch the freezer door. |
4. Place the hole in the bottom of | 5. Insert the left upper hinge shaft | 6. Insert the upper hinges into the holes |
the left d oor over the middle | into the hole on the corner of the | at the top of the door. |
hinge. | fridge door. | Insert and tighten the 3 hex head |
|
| bolts into the left and right upper |
|
| hinges with a socket wrench. |
ground
wire 
Top Table
7. Insert and tighten the ground | 8. Connect the electronic wire on | 9. Position the top table in place. |
screw into the left and right | the top of the refrigerator. | Insert and tighten the 3 screws |
upper hinges with a philips |
| into the top table with a philips |
screwdriver(+). |
| screwdriver(+). |
12_ setting up | setting up _13 |
