Removing the Accessories

The use of the Accessories

Refrigerator shelf

Lift the back of the shelf up to take it out.

(Its location can be changed as per the heights of the containers)

Fruit box cover

Lift the back of the fresh fruit drawer cover up to take it out.

Freezer Drawer

Pull it out till the edge and then lift it up to remove it; If it contains heavy articles, you need to lift it up slightly to put it back;

Egg Tray and Large Bottle Guard

Lift them up to take out.

Replacing the lamp bulb

Pull out the power plug.

Insert the (+)screw driver into the lamp cover from the gap and lift the cover up to take it out.

Turn the bulb counterclockwise to take it out.

Turn the new bulb clockwise.

Put the lamp cover back into the slot. Fasten the screw back at the back of the lamp cover.

Parameter of the lamp bulb: 220V/240V, 30W E14.

Installation Instructions

Your refrigerator should be put in a solid and level place. The adjusting leg on the bottom of the refrigerator shall be turned to adjust its horizontal location if not level. (lifting it up counterclockwise)

The distance between the wall and rear or sides of the refrigerator should not be less than 55 mm and the top clearance shall not be less than 55mm.

Keep the appliance away from any heat sources and avoid the direct sunlight.

The appliance should not be put in a humid environment to avoid that its metal parts become rusty or their insulation effects get reduced. In case of any natural disasters (i.e. storm, accident), if the refrigerator has been soaked in water, you should go to the appointed local SAMSUNG service centre for repair. You can use it again only when you make sure if there is no problem.

For the safety concerns, the refrigerator must be earthed correctly and shall not be earthed through telephone wire or gas pipe.

Do not have the power cord pressed by any object.

12

5

Page 6
Image 6
Samsung RL34SCSW1/XEO manual Removing the Accessories, Installation Instructions