INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply & |
|
| |
| water supply line. |
|
|
2) | Run water through the dispenser until the water runs clear | ICE | WATER |
| (6~7 minutes). This will clean the water supply system and |
|
|
| clear air from the lines. |
|
|
3) | Additional flushing may be required in some households. |
|
|
4) | Open the fridge door and check if water leaks around the |
|
|
| water filter. |
|
|
| • A |
| |
NOTE |
|
| |
Check the amount of water supplied to the ice tray.
1)To remove : Set the type of ice to the “Ice Off” position. Lift up (①) and pull out (➁) the ice bucket in the freezer.
ICE BUCKET
To replace : When replacing the drawer, be sure to press it firm- ly into place. If it does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push the drawer back again.
2) Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm. When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.
It is normal for several cubes to be joined together.
If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.
Rotate
| Drive |
Feeler Arm | Mechanism |
|
• Place the ice tray at the originally provided posistion by manufacturer in order to achieve optimal NOTE
INSTALLATION INSTRUCTIONS
35
