ADJUSTING THE HEIGHT BETWEEN THE DOORS

If the Arctic Select Zone Door is lower than the Fresh Select Zone Door.

adjustment part

Arctic Select Zone

Fresh Select Zone

1)Locate the height-adjuster () in the Arctic Select Zone. Unscrew the four phillips screws () slightly to loosen the door.

2) Unscrew the adjuster-phillips screw () two turns to rotate the adjuster.

3) Find the best adjuster-level to align the door gap.

CASE) The gap is about 2mm (0.08inch) as shown below.

gap

Arctic Select Zone Door

Fresh Select Zone Door

reference plane

-Rotate down the adjuster-face with +2.0 number to reduce the door gap.

-The number of the adjuster to rotate depends on the gap.

After adjustment, tighten the screws (& ) in reverse order.

The adjuster in the Fresh Select Zone can be used in the same way.

NOTE

INSTALLATION INSTRUCTIONS

23

Page 23
Image 23
Samsung RM257AB*, RM255AB* owner manual Adjusting the Height Between the Doors