CHECKING THE WATER DISPENSER LINE

1)In order to operate the ice maker properly, water pressure of 1.4 ~ 8.5kgf/cm2 (0.14~0.83Mpa, 19.9~120.9psi, 1.37~8.3bar) is required.

In this range a 100 cc paper cup can be filled in 10 seconds.

2)The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3)If the refrigerator is installed in an area with low water pressure (1.4kgf/cm2, 0.14Mpa, 19.9psi, 1.37bar), you should install a booster pump to compensate for the low pressure.

4)Ensure the water storage tank inside the refrigerator is preperly filled initially. Push the water dispenser lever until the water runs from the outlet.

A universal water supply kit is available at extra cost from your dealer. The refrigerator NOTE manufacturer recommends using a water supply kit containing copper tubing.

Checking the Parts

Water pipe

Pipe-Connect Water Packing

INSTALLATION OF THE WATER DISPENSER LINE

(Case 1)

Connecting to water supply line

- Shut off the main water supply line and turn the Ice maker to the off position.

- Locate the nearest cold drinking water line.

- Follow the instructions in the ice maker installation kit.

1.Cold Water line

2.Pipe Clamp. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut.

32

Page 32
Image 32
Samsung RM255AB*, RM257AB* owner manual Checking the Water Dispenser Line, Installation of the Water Dispenser Line