Attach Backhoe Mounts to Backhoe
NOTE: Leave all hardware loose until backhoe has been mounted to the tractor.
1.Attach right backhoe mount (3) and left backhoe mount (4) to backhoe frame.
2.Secure into position using six (three per bracket) cap screws (10), hardened flat washers (13), and hex nuts (17).
3.Secure crossbrace (5) to backhoe brackets using four cap screws (12), hardened flat washers (15), and hex nuts (19).
3.1014450 Right backhoe mount
4.1014451 Left backhoe mount
5.1014467 Crossbrace
10.735 3/4 NC x 2 HHCS GR5
12.24576 1/2 NC x
13. | 57798 | 3/4 Hardened flat washer | Figure 9. Backhoe Bracket Installation | |
15. | 57816 | 1/2 Hardened flat washer | ||
|
17.1450 3/4 NC Hex nut
19.1093 1/2 NC Hex nut
HOSE KIT INSTALLATION
Keep hands and body away from pressurized lines. Use paper or cardboard, not hands or other body parts to check for leaks. Wear safety gog- gles. Hydraulic fluid under pressure can easily penetrate skin and will cause serious injury or death.
Make sure that all operating and service per- sonnel know that if hydraulic fluid penetrates skin, it must be surgically removed as soon as possible by a doctor familiar with this form of injury or gangrene, serious injury, or death will result. CONTACT A PHYSICIAN IMMEDIATELY IF FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and valves are in good condition and not leaking before starting power unit or using equipment. Check and route hoses carefully to prevent dam- age. Hoses must not be twisted, bent sharply, kinked, frayed, pinched, or come into contact with any moving parts. Operate moveable components through full operational range to check clear- ances. Replace any damaged hoses immediately.
8 Installation | MAN0715 (rev. 10/31/2008) |
|
|
