12 Installation
MAN0715 (rev. 10/31/2008)
Mount Backhoe to Tractor (Continued) Refer to Figure 16.
5. Using the back hoe hydraulics position the back-
hoe brackets at a slight angle, approximately 5 to
10 degrees.
6. Raise backhoe up by l owering stabilizers and
boom section until backhoe mounting pins on
backhoe brackets are slightly lower than tractor
bracket hooks.
7. Slowly move tra ctor back until backhoe brackets
are positioned below the tractor bracket hooks.
Set tractor brake.
8. Raise backhoe br acket bottom mounting pins into
tractor bracket bottom hooks.
9. Rotate backhoe bracket uppe r mounting slots
over tractor bracket mounting hole and align
holes.
10. Install cap screws (9) and slotted hex nuts (16).
Tighten with 1-1/2 inch open end wrench provided
with kit. Return wrench to storage position (see
Figure 16).
11. Secure hex nut into position with klik pin (20).
12. Shut o ff tractor and remove key.
13. Tighten hardware wi th backhoe secured to the
tractor. This will ensure proper alignment and fit-
up for future installation.
1/2 NC x 1-34. . . . . . . . . . . . . 85 lbs-ft (115 N-m)
3/4 NC x 2 . . . . . . . . . . . . . . 297 lbs-ft (403 N-m)
14. Reinstall s eat.
15. Start tractor and put bac khoe into transport posi-
tion (see backhoe operator’s manual).
NOTE: Install swing lock before transporting.
Figure 16. Backhoe to Tractor Installation
9. 1006860 1" NC x 4 Cap screw GR5
16. 1006861 1" NC Slotted hex nut
20. 62043 1/4 x 1-3/4 Klik pin