INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
1)Slip the compression nut and plastic ferrule through the plastic tube.
2)After inserting the sleeve, tighten the compres- sion nut onto 1/4” compression fitting(union).
Do not overtighten the compression NOTE nut.
3)Slip the compression ferrule and nut on cop- per (or plastic) tubing as shown.
Tighten the compression nut onto the com- pression fitting(union).
4)Turn water on and check for any leakage.
Compression Nut
Ferrule
Sleeve
Compression fitting
Ferrule 
Compression Nut
Water line must be connected to drinkable water only.
NOTE Cut off 1/4 inch squarely to prevent leaks when reconnecting.
Install the water filter.
1) As shown, open the cartridge cover by pulling and pushing up at the front
The water filter cartridge is located at the upper right corner of the Fridge compartment.
NOTE When the display in the control panel indicates “filter change”, it is recommended that the filter cartridge be changed.
2) Remove the water filter from the box then position the arrow of the cartridge in line with the cartridge cover.
Under the high water pressure, water may drip from the water filter’s case.
NOTE If you put the small tray beneath the filter cover hole, it will be helpul to clean the shelf.
3) Insert the filter as shown and Push until you hear a click.
NOTE
Be sure to align the filter cartridge hook and housing.
4) Close the filter cartridge cover.
NOTE After changing the filter cartridge, throw away the first six glassfuls of water to flush out trapped air. Do not push and pull the water cartridge repeatedly, as water pressure will make the water spurt.
32
