Samsung RS21HPLMR1/ZA manual Replacement Instructions, Attach the purifier lock-clip

COUPLER “A”

		TAP
	LINE OUTLET
SIDE OF	90 degree
PURIFIER		CAUTION
PURIFIER WATER		Insert Locking Clip After
		tube seated
WATER INLET	COUPLER	Locking Clip
SIDE OF PURIFIER

Replacement Instructions

1.Shut off water supply.

2.Note the Flow direction on the fi lter.

3.Insert water supply tube into the inlet side of the fi lter until the tube stop.

FLOW DIRECTION

Remove any residual matter inside the purifier. (Model with the purifier)

-Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifi er.

-If water does not come out through the line, check whether the tap is open.

-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.

OUTLET SIDE	PURIFIER
OF PURIFIER
WATER	WATER LINE

Attach the purifier lock-clip.

-Hold the purifi er lock-clip in the appropriate position (under the sink for example) and fi x it tightly into place where to screw.

01 SETTING UP

WATER SUPPLY	PERMEAT
INLET SIDE

Note : You must also ensure that the cut is square and not at any sort of angle as this could cause a leak

4.After inserting tube, put together the clip strongly. The Clip fi x the tube.

PURIFIER LOCK-CLIP

Secure the purifier in position.

-Fix the purifi er in position, as shown in the fi gure on the right.

WATER TUBE

PURIFIER LOCK-CLIP

PURIFIER

5. Turn on the water and check for leaks. If leaks occur, repeat step 1,2,3,4. If leaks persist, discontinue use and call your supporting dealer.

6. Flush fi lter for 5 minutes before use.

setting up _21

DA99-02318T-00.indb 21 14. 6. 10. ￿￿ 8:25