First things fi rst! Make sure that you can easily move your refrigerator to its fi nal location by measuring doorways (both width and height), thresholds, ceilings, stairways, etc.

The following chart details the exact height and depth.

 

MODEL

 

RS26TDA**

 

RS26TKA**

 

Width

Only Cabinet

 

908

 

 

 

 

 

 

With Leg Front

 

915.5

 

 

 

 

 

Only Cabinet

 

746.5

 

 

With Door

 

857.5

 

 

 

 

 

 

Dimensions

Depth

With Handle

 

922.5

[mm (inch)]

 

90 ˚ Open

F 1,169.5 / R 1,295.5

 

 

 

 

 

 

 

135 ˚ Open

F 1,013.5 / R 1,103.5

 

 

 

 

 

 

 

 

Only Cabinet

 

1,752

 

 

 

 

 

 

 

Height

With Hinge

 

1,776

 

 

 

 

 

 

 

 

With Door

 

1,774

 

 

 

 

 

 

• Allow clearance to the right, left, back and top when installing. This will help reduce power consumption and keep your energy bills lower.

•Make sure you disconnect the water supply line BEFORE removing the freezer door.

To avoid damage, refer to ‘Separating the water line from the refrigerator’ in the manual (page 14).

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.

If not, fi rst check the power supply and electricity source or try the troubleshooting section at the back of this user’s guide. If you have any further questions, contact your Samsung Electronics service center.

1.Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the Refrigerator. Refer to installation instructions in this manual.

2.Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.

3.Set the Temperature control [Refer to ‘Freezer/Fridge(Temperature adjustment)’, page 23] to the coldest temperature and wait for an hour. The Freezer will get slightly chilled and the motor will run smoothly.

4.After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the Refrigerator after the temperature is suffi ciently cool.

5.Assemble the water line to the refrigerator and verify that the couplers are correctly assembled without water leakage. (Refer to ‘Installing the water dispenser line’, page 19~20)

Check the accessory list below.

UP SETTING 01

Hex wrench

Compression fi tting

Compression nut

Clip fi tting lock(red)

setting up _11

DA68-02535D(0.0).indb 11

2013.3.8 11:0:11 AM