When the Fridge part is lower than the Freezer part.
Insert a fl
Refer to the next section for the best way to Adjust the height difference between doors.
ADJUSTING THE HEIGHT DIFFERENCE BETWEEN DOORS
If one door is lower than the other.
•You can use the adjustable nut at the
bottom of the fridge/ freezer to adjust the height difference between the doors.
•An excessive adjustment
may cause interference between the door and the top hinge while opening/closing the door.
1.Open the door to adjust it. Use the provided wrench to turn the bottom adjustable nut ( a )
as far clockwise ( 
) as necessary.
Open the door and make adjustments inside the door.
2.Use the provided wrench to turn the height adjustable nut ( b ) as far counter clockwise
( 
) as necessary.
(Turn it counter clockwise ( 
) to lift the
door up; turn it clockwise ( 
) to lower the door.)
08_ setting up
3.When the height is aligned on both sides, use the wrench to turn the adjustable nut ( a )
counter clockwise ( 
) to tighten it.
If you adjusted the height of the product while it is empty, adding food later may eventually cause a height difference due to the added weight. If this is the case, follow the steps above to adjust the height again.
SETTING UP THE REFRIGERATOR
Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational.
If not, fi rst check the power supply and electricity source or try the troubleshooting section at the back of this user guide.
If you have any further questions, contact your Samsung Electronics call center.
1.Place the refrigerator in an appropriate location with reasonable clearance between the wall and the refrigerator.
Refer to installation instructions in this manual.
2.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3.Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4.After powering the refrigerator, it will take a few hours to reach the appropriate temperature. Once the refrigerator temperature is suffi ciently cool, you can store food and drink in the refrigerator.
2012.3.5 4:55:52 PM |
