3.After adjusting the doors, turn the nut 1 clockwise the bolt, then tighten the bolt again with the wrench
until it reaches the lower end of 3 to fix the nut in place 1 .
3 | Wrench | |
| 2 | Bolt |
1 | Nut |
|
If you do not secure the nut firmly, the bolt may release.
CHECKING THE WATER DISPENSER LINE (optional)
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup can be filled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can find it in freezer drawer.
Installing the water dispenser line
Parts for water line Installation
Water line fixer | Pipe | Water line | Filter |
|
and screws | connector |
| Filter | |
|
| |||
|
|
|
| |
|
|
|
|
|
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1.Close the main water tap.
2.Connect coupler “A” to the tap. Note:
WARRANTY INFORMATION
This water line installation is not covered by the refrigerator or ice maker manufacturer’s warranty. Follow these instructions carefully to minimise the risk of expensive water damage.
Note:
If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings.
CAUTION
The water line must be connected
to the cold water pipe.
If it is connected to the hot water pipe, it may cause the
filter to malfunction.
COUPLER “A”
TAP
