Samsung RSG257AABP user manual Removing any residual matter inside the water

Models: RSG257AABP

1 32
Download 32 pages 40.32 Kb
Page 17
Image 17
Removing any residual matter inside the water
setting up _17

4. Remove the filter cap and insert the filter

 

 

 

into the filter housing.

4

Cover filter

5

5. Slowly turn the water filter 90º clockwise

 

 

 

to align with the printing mark on the

 

 

 

cover, locking the filter in position. Make

 

 

 

sure to align the water filter label mark

 

 

 

with center of cover filter printing as

 

 

 

illustrated. Remember, do not over-

 

 

 

tighten.

 

Separation

Align the indication

 

 

of red cap

mark with lock position

Removing any residual matter inside the water

 

 

supply line after installing filter.

Ice

Water

 

1. Turn ON the main water supply.

2.Press the Water button and push the dispenser pad.

3.Run water through the dispenser until the water runs clear (approx.

3L). This will clean the water supply system and remove air from the lines.

4. Additional flushing may be required in some households.

5. Open the refrigerator door and make sure there are no water leaks coming from the water filter.

A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.

Check the amount of water supplied to the ice tray.

1. Lift up the icemaker cover and gently pull it out.

2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct(see the illustration below).

If the water level is too low, the ice cubes will be small. This is a water pressure problem from within the main water pipes, not the refrigerator.

1

Check the water level

Ice maker

2

 

Test button

- It will take a few minutes to reach the amount of water you want.

CAUTION - Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice jamming may occur.

-When the bucket is not installed, the ice maker does not work.

-When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s installed properly.

PU G 01TTINSEsupply line after installing filter.

Page 17
Image 17
Samsung RSG257AABP user manual Removing any residual matter inside the water, supply line after installing filter