CHECKING THE WATER
DISPENSER LINE
A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.
In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds.
If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure.
Make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water Line installation Kits are included with unit. You can fi nd it in freezer(or fridge) drawer.
The new
Parts for water line Installation
1 Water line fixer 2 Pipe connector | 3 Water line |
and screws |
|
4 Clip | 5 Water Filter |
Close Main |
Water pipe |
Close Main | No gap | 01 | |
| |||
Water pipe |
| SETTING | |
4. After connecting the water supply to the water | |||
| |||
filter, turn your main water supply back on and | UP | ||
Dispense about 3L to clear and prime the water | |||
| |||
filter. |
|
| |
INSTALLING THE WATER
DISPENSER LINE
Connecting the water line to the refrigerator
1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.
2.Connect both water line from the unit and water line in the kit
3.Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4.Turn water on and check for any leakage.
Loosen a | Remove | |
cap | ||
|
Connecting to the water supply line
1.First, shut off the main water supply line.
2.Locate the nearest cold, drinking water line.
3.Follow the Water Line Installation Instructions in the installation kit.
CAUTION
The water line must be connected to the cold water pipe.
If it is connected to the hot water pipe, it may cause the purifier to malfunction.
Water Line |
from unit |
Water Line |
from Kit |
No gap |
setting up _11
14. 7. 17. 3:27 |
