To Refit The Ice Bucket
-Assemble it in the reverse order
of disassembly.
- Push the bucket in firmly until you hear a clicking sound.
- When the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in figure 2.
Normal Operation
-Any sounds you hear when
the ice maker dumps ice into the bucket are part of normal operation.
- Not dispensing ice for long periods may cause ice clumps in the ice bucket. Remove the remaining ice and empty the bucket.
- When ice does not come out, check for any ice stuck in the chute and remove it.
-The first batch of ice cubes may be small due to air in the pipe after connection, any air will be purged during normal use.
- When ICE OFF blinks on the display panel,
CAUTION | reinsert the bucket and/or make sure it’s |
| |
| installed properly. |
-When the door is open, the Ice and water dispenser do not work.
-If you close the door hard, it may cause water spilling over the ice maker.
-To prevent dropping the ice bucket, use both hands when removing it.
-To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
-Do not let the children hang on the ice dispenser or on the bucket. They may get hurt.
-Be sure not to put your hand or any object into the ice chute. It may cause personal injury or damage mechanical parts.
SETTING UP THE REFRIGERATOR DOORS
If your entrance won’t allow the refrigerator to pass easily through it, you can remove the doors.
Removing the Front Leg Cover
First, open both the freezer and refrigerator doors, and then take off the front leg cover by turning the three screws
| 01 |
Separating the Water Supply Line | SETTING UP |
from the Refrigerator (Optional) |
|
1.Remove two water lines (gray one is for ice and the other one is for water) by pressing the coupler 1 and pulling the water line 2 away.
1 |
2
Be careful that the water tube match same color.
Reattaching the Water Supply Line
1.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.
center of transparent coupler
setting up _07
14. 7. 17. 3:27 |
