Installation
Metal plate
Detachable
Front panel
Caution
When you install this unit in your car, do not remove the detachable front panel.
If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.
Caution
Do not block the unit’s fan or heat sink, thus preventing air circulation. If blocked, heat will accumulate inside the unit and may cause a fire.
Air ventilation hole
(Rear of
1
Mounting Sleeve (Included)
Dashboard
this unit
Slide the mounting sleeve into the dashboard.
2
Screw
Hex Nut (M5)
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
3Slide the
Removal
1 Remove the detachable front panel.
2Insert the bracket keys into the slot and through the guides on either side of the unit. The unit can now be removed from the mounting sleeve.
This unit
Bracket Keys (Included)
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Screws (M5 ⋅ 8)
(Included)
this unit
Ground Lead
*3
Mounting Bracket
Metal
Mounting
Strap
*2 Bolt Stud
*1
this unit
•Secure the ground lead of the unit to a clean metal spot using a screw (*3) already attached to the vehicle's chassis.
Ground Lead | Chassis |
Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (*1) already attached to the vehicle's chassis.
•For the screw marked “*2”, use an appropriate screw for the chosen mounting location.
