Installation Instructions (cont'd)
USE WITHOUT POWER CORD (cont'd)
3.A standard _" conduit opening has been made in the water heater junction box for the conduit connection.
4.Use wire nuts and connect the power supply wiring to the wires inside the water heater's junction box.
5.The water heater must be electrically "grounded" by the installer. A green ground screw has been provided on the
WIRING DIAGRAM
_v
ON_F
SW;TCH
GA$
P_ESSURE
SWITCH
laOV GAS |
|
|
SOLENOID | HI.UMIT |
|
| SWlTC_ N_ N O | _¢ |
RESW_TCH
INOICATOn LIGHT I_V
o
Venting
water heater's junction box. Connect ground wire to this location. For complete grounding details and all allowable exceptions, refer to local codes or in the absence of local codes, with the latest edition of the National Electrical Code, ANSI/NFPA 70.
6.Replace the wiring junction cover using the screw provided.
Ain PRE$$UnE
sWITCH
F\
_ J
| _ |
| ItL_CK |
HOT | _ | _ | _ITE |
NEuTnAc |
| ||
...... 11I[ WXlTE....
I
[
*_v GAS SOLENOIO
AWARNINGI
To insureproperventingof this gas.firedwater heater,the cor- rect vent pipe diameter must be utilized. Any additions of other gas appliances on vent with this water heater will
[ adversey affectthe operationofthe water heater. | I |
The combustion and ventilation air flow must not be obstructed.
AWARNING | ] |
The water heater with_stalled | must be properly |
vented to a chimneywhichterminatesoutdoors.Never
sionor asphyxiation. | ] |
AWARNING
Obstructed or deterioratedventsystemsmay presenta serious
healthrisk or asphyxation.
_,WARNING
The vent pipe from the water heater must slopeupward I/4 nch per near foot.
All vent gases must be completely vented to the outdoors of the structure (dwelling).
MIN. RISE I/4"
PERFOOT
I
Failureto haverequired clearancesbetweenwater heater
_,WARNINGand
combustibe material wi resu t n a Erehazard.
16
