CHECKING THE WATERDISPENSER LINE

A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that.

In order for the icemaker to operate properly, water pressure of 138 ~862 kPa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds.

If the refrigerator is installed in an area with low water pressure (below 138 kPa), you can install a booster pump to compensate for the low pressure.

Make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water Line installation Kits are included with unit. You can fi nd it in freezer(or fridge) drawer.

The new hose-sets supplied with the appliance are to be used and that old hose- sets should not be reused.

Parts for water line Installation

1 Water line fixer 2 Pipe connector

3 Water line

and screws

 

CAUTION

The water line must be connected to the cold water pipe.

If it is connected to the hot water pipe, it may cause the purifi er to malfunction.

Close Main

Water pipe

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Close Main

 

No gap

Water pipe

 

 

 

 

 

 

 

 

 

 

 

4.After connecting the water supply to the water

lter, turn your main water supply back on and Dispense about 3L to clear and prime the water

lter.

INSTALLING THE WATER DISPENSER LINE

Connecting the water line to the refrigerator

1.Remove the cap from water line on the unit and insert compression nut to the water line on the unit after disassembling from provided water line.

2.Connect both water line from the unit and water line in the kit

3.Tighten the compression nut onto the compression fi tting. Be careful no gap between two items.

4.Turn water on and check for any leakage.

4 Clip

5 Water Filter

Connecting to the water supply line

1.First, shut off the main water supply line.

2.Locate the nearest cold, drinking water line.

3.Follow the Water Line Installation Instructions in the installation kit.

Remove

Loosen a

cap

Water Line from unit

No gap

Water Line from Kit

16_ setting up