Samsung C4203(P), SCC-C4201(P), C4301(P), C4303(P) manual Exit

In low light conditions, the IR Filter is turned OFF and the sensitivity to low light is increased by switching to the BW mode, but in bright light conditions, the IR Filter is turned ON and the sensitivity is decreased by switching to the COLOR mode. If you select AUTO and press the ENTER button, a screen from which you can set the ALARM ON/OFF, BURST ON / OFF, BW LEVEL and DWELL TIME will appear.

-ALARM ON : It sends out signals through the ALARM output port in the BW mode.

-ALARM OFF : The ALARM output port is synchronized with the MOTION DET finction regardiess of the COLOR/BW mode.

-BURST ON : The color burst signal is output together with black and white composite video signal.

BURST OFF : The color burst signal is not output.

-LEVEL : You can set the brightness level that changes from

COLOR mode to BW mode in 3 steps : LOW, MEDIUM, and HIGH.

-DWELL TIME : Set the HOLDING time for switching between COLOR and BW mode depending the changes in the amount of light. You can set the HOLDING time to 10sec (S), 30sec, 60sec, or 300sec( L).

In AUTO mode, AGC will operates in high speed mode, and you cannot change it manually, as it is indicated by "---".

EXIT

The EXIT option is used to quit the Setup Menu mode and return to the Normal Operation mode.

☞QUIT : Select to ignore any changes you have made and restore the previously saved settings.

☞SAVE : Select to save the settings that have been changed so far.

☞ PRESET : Select to ignore any changes you have made E and restore the factory default settings.

(SET UP)

CAMERA ID	OFF
IRIS	ALC...
SHUTTER	OFF
AGC	---
WHITE BAL	ATW
SPECIAL	...
AUTO FOCUS	ONEAF
MOTION DET	OFF
PRESET	...
COLOR/BW	AUTO...
EXIT	QUIT

Press the

ENTER button.

(BW SETUP)
	OFF
ALARM
BURST	ON
LEVEL	MEDIUM
DWELL TIME	S------L
RET

Caution : If you use an infrared light source while in AUTO mode, AUTO switching malfunction and camera AF malfunction may occur.

27 28