Installing the Camera
1.[Figure 1] Install the structure on the ceiling.
(Refer to Installation reference for the Length of the structure)
*Built in by the builder of the structure
[Figure 1]
2.Make a hole in the ceiling where the camera will be installed. (The hole should be about ø185)
3.[Figure 2] Assemble the
Length of ceiling Hole
5.[Figure 5] Match the
[Figure 5]
7. [Figure 7] Match the 3 holes on the |
back of the CAMERA and the |
CONNECTOR and turn it left about |
15 degrees. |
(Check the sound of LOCKING |
6.Pull the safety wire from the case body, and assembly it to the camera holder.
[Figure 6]
E
[Figure 7]
[Figure 2]
4.[Figure 3,4] Connect the various cables to the CAMERA ADAPTER. (See page
[Figure 3]
[Figure 4]
and that the |
is in place) |
* Use the screws (BH M3 x L8) to |
connect the CAMERA and the |
ADAPTER so they don't move. |
8. [Figure 8] Assemble the |
[Figure 8]