Samsung SCC-C6405P ZONE DIR SET, ZONE AREA, LOCATION, ZONE ID SET, ZONE ENABLE

ZONE DIR SET

Press the [Enter] key in the “ZONE DIR SET ON…” mode to enter the NORTH SET screen. MAP. Move PAN to set the NORTH position and press [ENTER]. Based on the North position,the direction of N(North), NE(North-East), E(East), SE(South-East), S(South), SW(South-West), W(West), NW(North-West) is displayed whenever you move PAN.

(ZONE SET)
			NORTH SET
PRIVACY ZONE	...	➜
ZONE DIR SET	ON...
ZONE AREA SET	OFF
				N
		Press
		[Enter]
EXIT	QUIT

ZONE AREA

Press [ENTER] to enter the ZONE AREA MAP screen from “ZONE

AREA SET...”. Select a ZONE AREA number from the ZONE AREA MAP

screen and press [ENTER] to enter the ZONE AREA setup screen.

(ZONE SET)			(ZONE AREA MAP)
PRIVACY ZONE	...
ZONE DIR SET	OFF	➜	0	*	1	2	3
			4		5	6	7
ZONE AREA SET	ON...

Press [Enter]

EXITQUIT

RET

	ZONE AREA SET	0
		...
➜	LOCATION
	ZONE ID SET	...
Press	ZONE ENABLE	ON
[Enter]
	EXIT	QUIT

LOCATION

The “LOCATION...” menu designates the left/right LIMIT positions of ZONE AREA. Enter the setup screen to move PAN, then select a start position and press [ENTER]. Move PAN again

to select a end position and press [ENTER]. Now, ZONE AREA setup is complete.

ZONE AREA SET		0
				SET START!
		...
LOCATION					➜
ZONE ID SET		...	➜			E
ZONE ENABLE		ON
			Press		After P/R/Z
					control, press
			[Enter]
					[ENTER]
EXIT		QUIT
	SET END!
			After PAN control,
			press [ENTER] to
			finish.

ZONE ID SET

This function is used to allocate as many as 12 IDs to each zone area. Use Left , Right, UP, or DOWN for this purpose. You may select the ID position from the additional menu of “LOCATION...”.

			ZONE AREA ID 0
ZONE AREA SET	0
LOCATION	...				B C D E F G H I J K L
		➜		A
ZONE ID SET	...			M N O P Q R S T U V W X
ZONE ENABLE	ON			Y Z 0 1 2 3 4 5 6 7 8 9
		Press			: ! - + ✽ ( ) /
				SP ïî SP
		[Enter]
				LOCATION...
				RET
				ZONE 0........
EXIT	QUIT

ZONE ENABLE

This function turns on or off the ZONE AREA ID indication.

3-21 3-22