Conair MPW, MPA manual Disabling Or Enabling Output Monitors, Select the OM Enable/Disable menu

All output monitors on the microKool chiller can be enabled or disabled permanently through the OM Enable/Disable Menu in Test Mode.

You need to use this feature if you have replaced the mother- board, or if dip switches 7 and 8 have been changed erro- neously. This will enable any required output monitors that were disabled and give fuse failures.

1	Enable Test Mode.
	Press any key to display the first test menus.
2

DISABLING OR

ENABLING

OUTPUT

MONITORS

3

Select the OM Enable/Disable menu.

Press and hold the Setpoint key for 3 seconds to index to each test menu until the controller indicates “oS1” in the actual display and the status of the selected output in the Select display.

4

5

Press the Setpoint ▲ or ▼ key to change the status. Each press of the key changes the output status from ON to OFF or OFF to ON.

Press the Setpoint to select the next output.

Repeat Step 4 to change the status of the output, or press any key to continue indexing through the outputs.

6

Save changes and exit the output menu.

Press and hold the Select key for 3 seconds to save the changes and exit.

UGH004/0999 microKool Portable Chillers MAINTENANCE 5-11