Conair MPW, MPA manual Press the RUN button to save the passcode, Open the electrical, enclosure

ENABLING AND

DISABLING

PASSCODE

PROTECTION

7

Press the RUN button to save the passcode.

◆The control will display “Pr OFF” to prompt you to remove power to the unit.

IMPORTANT: If RUN is not pressed, the new passcode will not be saved.

8

9

10

11

Turn off power to the unit. Disconnect and lock out the main power supply.

Open the electrical	8 7 6 5 4 3 2 1
enclosure.

Set dip switch 3 to OFF.

Close the electrical enclosure and restore power to the unit.

A passcode now is required to change system parameters.

Disabling Passcode Protection

To disable passcode protection and allow universal access to system parameters:

1

Follow Steps 1 through 5 in the

previous section on enabling pass- code protection.

2

3

Hold down the ▼ setpoint adjustment button to select “OFF” as the new passcode.

Follow steps 7 through 11 in the previous section.

UGH004/0999 microKool Portable Chillers INSTALLATION 3-11