To connect Alarm OUT | Samsung SCC-C7453N manual

installation & connection

To connect ALARM IN

1.Connect one end of the external device's signal line to a corresponding ALARM IN port of the monitor.

2.Connect the other end of the signal line to the earth-grounding [GND] port.

To connect ALARM OUT

1.Connect one end of the external device's signal line to a corresponding ALARM OUT port of the monitor.

2.Connect the other end of the signal line to the common [COM] port.

To connect the controller

Connect an external controller or DVR to the camera, with which you can adjust the camera.

1.Connect the Rx+ pin of the camera to the Tx+ pin of the controller.

2.Connect the Rx- pin of the camera to the Tx- pin of the controller.

3.Connect the Tx+ pin of the camera to the Rx+ pin of the controller.

4.Connect the Tx- pin of the camera to the Rx- pin of the controller.

Rx Tx

20_ installation & connection

00956B-NA_SCC-C7453N-ENG.indb 20

2009-08-13 오후 10:58:

Image 20

Samsung SCC-C7453N user manual To connect Alarm OUT, To connect the controller

Contents

Smart Dome Camera Overview English Overview FCC Statement Important safety instructions Contents Features What’s Included Frame SET At a GlanceCamera Installation & connection Optional Accessories for Installation English Precautions HousingPreparation Cable Installation Power BNC Cable Bush 24V Cable Housing MountPIN Bush Bush 22P Connector Housing Rack Housing Camera Screws Cover Dome Gasket DomeFrame SET Hook Protective Camera Tape Cover Initial Setup Camera Address SetupCommunication Protocol Setup Samsung Half Samsung Full Baud Rate Setup Setting RS-422A/RS-485 TerminationUse pins #5, #6 of SW603 to set the baud rate Factory default is 9600 BPS RS-422A/RS-485 Full Duplex Organization Same address in the network Connecting with Other device Connecting to a monitorMonitor Alarm Alarm OUT CONTROLLER/DVR Power Source To connect the controller To connect AlarmTo connect Alarm OUT Adaptor Board Connecting the adaptor cablePower Supply Camera will resume the last run operation How to use the keyboard controllerUsing OSD icons Main Menu Profile DAY Mode NightBurst EXT Burst You can configure the general settings of the camera module Camera SETCamera ID  Location Specify the display position of the camera ID  Manual Adjust the iris level manually With this, you can adjust the AGC level of aIris AGC Motion DNRShutter SENS-UP You can specify a recording mode according to the scene FlickerlessXDR DAY/NIGHT SET-AUTO SET are not available Auto Switch or Auto FocusNeeded White BAL DAY/NIGHT Zoom Speed Display ZoomDisplay P/T Digital Zoom Sync AGC Color SUPReverse POSI/NEGA You can enable the motion detection and tracking functions When multiple motions continue arbitrarilyIntelligent Video Advanced Resolution Alarm OUTPrivacy Zone Display Preset Select the preset number Select Position and adjust PAN Auto Pan Setup Settings so define them again after the operationAuto SET You can set the Auto PAN, PATTERN, and Auto Play Position Direction Left Endless OFF Speed Select the Start and move the camera using pan/tilt/zoom Pattern SetupScan Setup Auto Play Setup ~ 511 for Preset Select Main MENU-ZONE SET Zone SETYou can set the north direction and the zone coverage Alarm SET Select Main MENU-ALARM SET  Auto SET Sets the pattern and scan Clock SET Other SET Factory Defaults PasswordOSD Color Proportional P/T Communication System InfoYou can check the system information Select Main MENU-SYSTEM Info Language You can set the language of the user interface Shortcut Keys Function Key INT/LINE Lock SpecificationsSmart Dome Camera PAN Tilt Product Appearance 00956B-NASCC-C7453N-ENG.indb 2009-08-13 오후